Troubleshooting: Lane Traffic Lights are Showing both the Red X and Green Arrow
Issue: The Lane Traffic lights show both the Red Closed X and the Green Open Arrow during open hours and when the lane is set to open on the Lane Controller switch panel.
Troubleshooting steps:
- Turn the Lane Traffic light on and off in rapid succession about 10 times.
- Move the selector switch from Open to Off to Close in rapid succession and then from Close to Off to Open in rapid succession.
- Perform this step 10 times.
- If this does not resolve the issue, move on to step 2.
- Move the selector switch from Open to Off to Close in rapid succession and then from Close to Off to Open in rapid succession.
- Check both the Lane Gate Open (LxSO) and Lane Gate Closed Relays (LxSC) are on.
- If both Relays are NOT on,
- Power off the CB1 Breaker,
- Remove both the Lane Open and Lane Closed Relays.
- Install spare or new relays (CCS-2961105).
- Turn the CB1 Breaker back on.
- Check to see if the Lane Traffic light is working correctly.
-
- If this does not resolve the issue, replace the relay module(CCS-2966171).
-
- Inspect the wiring for the shorts or contact an electrician to investigate the system for wiring issues.
- If Both Relays are ON
-
- Power off the CB1 Breaker,
- Remove both the Lane Open and Lane Closed Relays.
- Shake the Relays to loosen the contactors in the relay.
- Reseat the Relays.
- Turn the CB1 Breaker back on
- Check to see if the Lane Traffic light is working correctly.
- If this does not resolve the issue, replace the relays (CCS-2961105)
- If replacing the relays does not resolve the issue, replace the relay module (CCS-2966171).
-
- Inspect the wiring for the shorts or contact an electrician to investigate the system for wiring issues.
-
- If no shorts or wiring issues are found, replace the Lane Traffic light (TSS-TR120XS).
- If both Relays are NOT on,