Please see attached .PDF for the full documentation.
Pause Button Troubleshooting and RepairThis document will describe troubleshooting for when a pause buttonis shown to be “stuck” in theON position.All pause buttons are wired in sequence. This means any pause button in the tunnel or on the flightdeck can bring the conveyor to “pause” speeds.When pause buttons have not been activated but “pause” is showingto be activate, you will need anelectrician or experienced team member to put a VDC volt meter to each pause buttons set ofcontacts without pushing the pause button. The meter should read close to 0VDC on the GOODcontacts and around 24VDC on the BAD contacts. Any buttons that are not pressed and providingresults of 24VDC, need to be replaced. Be sure to inspect the contacts and wires for corrosion orother signs of moisture and water damage as this may cause the button to short out; which will senda signal to the controller telling it to bring the conveyor to “Pause” speeds.